A broken chair arm can be quite frustrating, especially if that chair is one of your favorite pieces of furniture. However, fixing a broken chair arm is not as difficult as it may seem, and in this article, we will guide you through the process.
The first step in fixing your broken chair arm is to gather all the necessary materials. You will need wood glue, clamps, a saw, sandpaper, screws, and a screwdriver. Once you have all the materials, you can move on to the next step.
Before you can fix the broken chair arm, you first need to remove it from the chair. Using your saw, carefully cut off the broken part of the arm. Make sure to cut it at a straight angle and as close to the chair as possible. Sand the rough edges until they are smooth.
Once you have removed the broken arm, you need to prepare the new arm. Take your saw and cut a piece of wood to the same size and shape as the broken arm. Use the sandpaper to smooth out any rough edges. Drill a hole at the end of the new arm that is opposite of the side that will attach to the chair.
Now that you have prepared the new arm, it's time to attach it to the chair. Apply wood glue onto the surface of the new arm that will be attached to the chair, and then press it firmly against the chair. Use the clamps to hold the new arm in place until the glue dries. Once the glue has dried, drill a screw into the hole you made in the new arm, securing it to the chair.
In conclusion, a broken chair arm can be easily fixed with a few simple steps. By following this guide, you can have your favorite chair back to its original condition in no time at all. Just be sure to take your time and be careful when cutting and drilling to avoid any injuries. Good luck!
"