how to upholster a curved back dining chair

Upholstering a curved back dining chair is not an easy task, but it can be a very rewarding project. The right materials, tools, and techniques are important to produce a high-quality and durable finish. This article will give you step-by-step instructions on how to upholster a curved back dining chair.

Materials and Tools

Before starting your project, gather the following materials and tools together:

• Upholstery fabric
• Upholstery foam
• Dacron batting
• Staple gun and staples
• Scissors
• Measuring tape
• Chalk or pen
• Needle-nose pliers
• Flathead screwdriver

Removing the Old Upholstery

The first step in upholstering a curved back dining chair is to remove the old upholstery. This can be done by using a needle-nose pliers and a flathead screwdriver to remove the staples that secure the old cover to the chair frame. Once you have removed the old upholstery, clean the chair thoroughly to remove any dirt or debris.

Preparing the Foam and Dacron Batting

Once the chair is clean and free from old upholstery, it is time to prepare the foam and Dacron batting. Measure the chair seat and backrest to determine the size of foam you will need. Cut the foam to size using scissors. Next, cut a piece of Dacron batting that is slightly larger than the foam. Lay the foam on top of the Dacron batting and wrap it around the foam, tucking any excess Dacron under the foam. Use the staple gun to secure the Dacron to the foam.

Upholstering the Chair

With the foam and Dacron batting prepared, it’s time to upholster the chair. Lay the upholstery fabric face down on a flat surface. Place the chair on top of the fabric, making sure it is centered. Starting at the seat of the chair, pull the fabric taut and staple it to the frame. Staple one side of the chair and then the opposite side to ensure an even tension. Continue stapling the fabric, working your way around the chair, pulling it tight as you go.

Finishing Touches

Once you have stapled the fabric to the chair frame, it’s time to add the finishing touches. Trim any excess fabric with scissors and fold under the edges to create a neat finish. If you have any excess Dacron batting showing, use the staple gun to tuck it under the fabric. Finally, add a dust cover to the underside of the chair, stapling it in place to finish the project.

Conclusion

Upholstering a curved back dining chair is a great DIY project that can add a beautiful touch to your home. While it may seem daunting at first, with the right tools and materials, it can be a fun and rewarding experience. Follow these easy steps, and you’ll be able to create a beautiful, custom upholstered dining chair that you can be proud of!