how to remove towel bar with no set screw

A towel bar is a common fixture in most bathrooms. Over time, it can become outdated, or you may simply want to replace it with a new one. But what do you do when there are no set screws to hold it in place? This guide will show you how to remove a towel bar with no set screw while minimizing damage to your wall.

Supplies

Before you begin, gather the following supplies:

• Thin putty knife
• Needle-nose pliers
• Flathead screwdriver
• WD-40 or similar lubricant spray
• Caulk softener (optional)

Assess the Situation

Take a close look at your towel bar. Is there a gap between the bar and the wall? If so, you may be able to slide a putty knife behind the mounting bracket to release it from the wall. If there is no gap, look for any screws on the mounting bracket. If there are no screws, your towel bar is likely held in place with an adhesive or caulk.

Remove Adhesive or Caulk

If your towel bar is held in place with adhesive or caulk, you'll need to soften it before attempting to remove it. This can be done with a caulk softener or a hairdryer set to high heat. Once the adhesive or caulk has been softened, use the putty knife to gently pry the mounting bracket away from the wall. Be careful not to damage the wall or the paint.

Release Mounting Bracket

If there are screws on the mounting bracket, use the flathead screwdriver to remove them. If there are no visible screws, try gently twisting the mounting bracket with the needle-nose pliers. If the towel bar is still firmly attached to the wall, try using a bit of WD-40 or similar lubricant spray to loosen it. Gently twist the mounting bracket with the needle-nose pliers until it releases from the wall.

Conclusion

Removing a towel bar with no set screw can be frustrating, but with the right tools and techniques, it doesn't have to be difficult. By following these steps, you can remove your old towel bar with minimal damage to your wall and prepare it for a new, updated fixture.

"